|Verse Number Font Size
|Page 1 of 1|
|Author:||beresbart [ Fri Jul 07, 2017 4:54 pm ]|
|Post subject:||Verse Number Font Size|
Getting older has it's problems. I find the verse numbers, being smaller than the verse text itself, difficult to scan quickly. How may I up the verse number font size?
Much thx for an excellent piece of software - I am an eSword convert.
|Author:||JG [ Fri Jul 07, 2017 11:58 pm ]|
|Post subject:||Re: Verse Number Font Size|
Welcome to the forum. Sorry I have taken so long to respond. I could not find off-hand what to do.
So, there is not a setting that will do this for you from within the program, but it needs the "config.ini" file to have some setting value placed in it.
There is a section at the end of the help file manual, that instructs about "working directly with the config.ini file." so follow that to get the file and have it ready to add the data.
You need to add this line just below the [general] section.
You change the value larger for increasing the font size, 8 is default size.
You must be sure that theWord is not running and that when you have added the above setting that you save and exit the file in your text editor, then start theWord and see if the 10 setting is ok or should be something different.
|Page 1 of 1||All times are UTC + 2 hours|
|Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group